Most UptoDate Cisco 350-401 Exam Dumps PDF 2025
100% Free CCNP Enterprise 350-401 Dumps PDF Demo Cert Guide Cover
NEW QUESTION # 48
Refer to the exhibit.
A network engineer configures a GRE tunnel and enters the show Interface tunnel command. What does the output confirm about the configuration?
- A. The keepalive value is modified from the default value.
- B. The physical interface MTU is 1476 bytes.
- C. Interface tracking is configured.
- D. The tunnel mode is set to the default.
Answer: D
NEW QUESTION # 49
Which statements are used for error handling in Python?
- A. catch/release
- B. try/catch
- C. block/rescue
- D. try/except
Answer: D
NEW QUESTION # 50
Which two characteristics define the Intent API provided by Cisco DNA Center? (Choose two.)
- A. northbound API
- B. procedural
- C. southbound API
- D. business outcome oriented
- E. device-oriented
Answer: A,D
Explanation:
NEW QUESTION # 51
Refer to the exhibit.
Which command set must be added to the configuration to analyze 50 packets out of every 100?
- A. Option D
- B. Option C
- C. Option B
- D. Option A
Answer: A
NEW QUESTION # 52
Drag and drop the characteristics from the left onto the routing protocols they describe on the right.
Answer:
Explanation:
NEW QUESTION # 53
Refer to the exhibit.
Which command set is needed to configure and verify router R3 to measure the response time from router R3 to the file server located in the data center?
A)
B)
C)
D)
- A. Option A
- B. Option C
- C. Option B
- D. Option D
Answer: A
Explanation:
https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-550x-series-stackable-managed-switches/smb5797-configure-ip-sla-tracking-for-ipv4-static-routes-on-an-sg550.html
NEW QUESTION # 54
Refer to the exhibit.
An engineer reconfigures the pot-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log.
Which command set resolves this error?
- A.
- B.
- C.
- D.
Answer: B
NEW QUESTION # 55
Refer to the exhibit.
What is the result when a switch that is running PVST+ is added to this network?
- A. Both switches operate in the Rapid PVST+ mode.
- B. Both switches operate in the PVST+ mode
- C. Spanning tree is disabled automatically on the network
- D. DSW2 operates in Rapid PVST+ and the new switch operates in PVST+
Answer: D
Explanation:
When a switch running Per-VLAN Spanning Tree Plus (PVST+) is added to a network with switches running Rapid PVST+, the network supports both protocols simultaneously due to the backward compatibility of Rapid PVST+ with PVST+. The existing switches will continue to operate using Rapid PVST+, while the newly added switch will operate using its configured protocol, which is PVST+. This ensures that there is no disruption in service and that spanning tree continues to prevent loops as expected.
NEW QUESTION # 56
How are control traffic, client authentication and data traffic handled in a mobility express environment?
- A. Control traffic and client authentication is handled locally by each access point. Data traffic is switched locally by the access points.
- B. Control traffic and client authentication is handled centrally by the controller. Data traffic is switched centrally by the controller.
- C. Control traffic and client authentication is handled centrally by the controller. Data traffic is switched locally by the access points.
- D. Control traffic and client authentication is handled locally by each access point. Data traffic is switched centrally by the controller.
Answer: C
NEW QUESTION # 57
Drag and drop the automation characteristics from the left onto the corresponding tools on the right.
Answer:
Explanation:
Explanation:
ChefRuby syntax in configuration filesAnsibleall functions are performed over ssh YAML configuration language Based on Python
NEW QUESTION # 58
An engineer must create an EEM applet that sends a syslog message in the event a change happens in the network due to trouble with an OSPF process. Which action should the engineer use?
- A. action 1syslog write "OSPF ROUTING ERROR"
- B. action 1 syslog pattern "OSPF ROUTING ERROR"
- C. action 1 syslog send "OSPF ROUTING ERROR"
- D. action 1 syslog msg "OSPF ROUTING ERROR"
Answer: D
NEW QUESTION # 59
Refer to the exhibit.
Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0724 network?
A)
B)
C)
D)
- A. Option
- B. Option
- C. Option
- D. Option
Answer: B
NEW QUESTION # 60
Simulation 01
BGP connectivity exists between Headquarters and both remote sites; however, Remote Site 1 cannot communicate with Remote Site 2. Configure BGP according to the topology to goals:
1. Configure R1 and R3 under the BGP process to provide reachability between Remote Site 1 and Remote Site 2. No configuration changes are permitted on R2.
2. Ensure that the /32 networks at Remote Site 1 and Remote Site 2 can ping each other.
R1
R3
Answer:
Explanation:
Solution:
On R1:
R1(config)#router bgp 123
R1(config-router)#address-family ipv4
R1(config-router-af)#neighbor 10.0.0.2 allowas-in
On R3:
R3(config)#router bgp 123
R3(config-router)# address-family ipv4
R3(config-router-af)#neighbor 192.168.1.2 allowas-in
VERIFICATION:
R3#sh ip route bgp
Gateway of last resort is not set
1.0.0.0/32 is subnetted, 1 subnets
B 1.1.1.1 [20/0] via 192.168.1.2, 00:01:17
2.0.0.0/32 is subnetted, 1 subnets
B 2.2.2.2 [20/0] via 192.168.1.2, 00:05:06
10.0.0.0/24 is subnetted, 1 subnets
B 10.0.0.0 [20/0] via 192.168.1.2, 00:01:17
Test Ping from R3 to R1:
R3#ping 1.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
!!!!!
R3#ping 1.1.1.1 source lo0
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
Packet sent with a source address of 3.3.3.3
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
NEW QUESTION # 61
Which there application has the ability to make REST calls against Cisco DNA Center?
- A. Mozilla
- B. Postman
- C. REST Explorer
- D. API Explorer
Answer: B
NEW QUESTION # 62
Refer to the exhibit.
Which privilege level is assigned to VTY users?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION # 63
Drag and drop the characteristics from the left onto the correct infrastructure deployment types on the right.
Answer:
Explanation:
Explanation
On premise: customizable,specific requirements,resources
Cloud: scale, built-in automated backup, strong stable internet
NEW QUESTION # 64
Drag and drop the characteristics from the left onto the protocols they apply to on the right?
Answer:
Explanation:
NEW QUESTION # 65
Which statement describes the IP and MAC allocation requirements for virtual machines on types 1 hypervisors?
- A. Each virtual machine requires a unique IP address but shares the MAC address with the physical server
- B. Each virtual machine requires a unique MAC address but shares the IP address with the physical server.
- C. Each virtual machine requires a unique IP and MAC addresses to be able to reach to other nodes.
- D. Each virtual machines requires a unique IP address but shares the MAC address with the address of the physical server.
Answer: C
Explanation:
Explanation
A virtual machine (VM) is a software emulation of a physical server with an operating system.
From an application's point of view, the VM provides the look
and feel of a real physical server, including all its components, such as CPU, memory, and network interface cards (NICs).
The virtualization software that creates VMs and performs the hardware abstraction that allows multiple VMs to run concurrently is known as a hypervisor.
There are two types of hypervisors: type 1 and type 2 hypervisor.
In type 1 hypervisor (or native hypervisor), the hypervisor is installed directly on the physical server. Then instances of an operating system (OS) are installed on the hypervisor. Type 1 hypervisor has direct access to the hardware resources. Therefore they are more efficient than hosted architectures. Some examples of type 1 hypervisor are VMware vSphere/ESXi, Oracle VM Server, KVM and Microsoft Hyper-V.
In contrast to type 1 hypervisor, a type 2 hypervisor (or hosted hypervisor) runs on top of an operating system and not the physical hardware directly. answer 'Each virtual machine requires a unique IP and MAC addresses to be able to reach to other nodes' big advantage of Type 2 hypervisors is that management console software is not required. Examples of type 2 hypervisor are VMware Workstation (which can run on Windows, Mac and Linux) or Microsoft Virtual PC (only runs on Windows).
NEW QUESTION # 66
......
Updated Cisco 350-401 Dumps – PDF & Online Engine: https://www.pdfvce.com/Cisco/350-401-exam-pdf-dumps.html
PDF Exam Material 2025 Realistic 350-401 Dumps Questions: https://drive.google.com/open?id=1mFBwcTordphEWqXuK399Wa6hQTOuDnpb